![real time acoustic echo cancellation using dsp zoom kit real time acoustic echo cancellation using dsp zoom kit](https://cdn11.bigcommerce.com/s-b2627/images/stencil/1280x1280/products/3782/11589/kit-zr-distance-learning-kit1-1__01185.1623695265.png)
![real time acoustic echo cancellation using dsp zoom kit real time acoustic echo cancellation using dsp zoom kit](https://m.media-amazon.com/images/I/81QYznUl0yL._AC_SL1500_.jpg)
Adjust each lobe's width (narrow, medium, or wide) and position as needed in the Properties panel.These coverage templates are designed and tested to fit most common installations. The first time you do this, you'll be prompted to choose an installation orientation. Drag your microphone onto the coverage map if it isn't there already.Microphone coverage is at the room level, meaning that there is one coverage map for all microphones in a room. To control microphone coverage, use Designer. If you remove or add devices, select Optimize again. Designer optimizes microphone and DSP settings for your equipment combination. Verifying that AEC reference signals are correctly routed.You can customize settings further, but the Optimize workflow gives you a good starting point.Īfter optimizing a room, you should check and adjust settings to fit your needs. The settings are optimized for your particular combination of devices. Enables LED logic control for applicable devices.Creates audio routes and mute control routes.When you select Optimize in a room, Designer does the following: Optimize also creates mute control routes in rooms with MXA network mute buttons. Use to attach the desk stand, the microphone stand mount, or other VESA MIS-B-compatible adapters.ĭesigner's Optimize workflow speeds up the process of connecting systems with at least 1 microphone and 1 audio processor. Route the Ethernet cable here to keep it flush with the microphone. Use to attach eyelet screws to hold braided metal cable or other high-strength wire for suspension mounting. Use to attach the microphone to the wall-mounting bracket. Power over Ethernet is required to power the microphone. You may need to try a few different holes to press the reset button. Use a small paperclip or other tool to press and hold the button. To access, find a grille hole that aligns with the left edge of the mute status LED and the "S" of the Shure logo. Note: If LEDs are disabled, they will still turn on when the device powers up or when an error state occurs. Multi-color flash, then blue (moves quickly back and forth across bar) Factory reset: Triggers device power-up.Network reset: Red (progresses along bar).Mute Status LED Default Settings Microphone Status Customize LED color and behavior in Designer by going to: Device configuration > Settings > Lights.